- >
- Brands
- >
- Exlar
- >
- Linear servo actuators
- >
- Tritex TDX
Exlar Tritex TDX
Linear servo actuator
- Embedded servo drive 24/48Vdc
- Continous force up to 3,8 kN
- 450 mm stroke - 846 mm/s



ery compact electric DC actuators with peak forces up to 6 kN. Existing of a linear roller screw transmission in an DC powered servo drive, with digital position controller, brushless motor and linear actuator in one sealed package. Connection to 12 - 48 Vdc power.
Incorporate a fully electronic solution in the space of your existing hydraulic or pneumatic cylinder or eliminate troublesome ball screw actuators.
2 sizes linear roller screw servo actuators (90 en 115 mm).
Power: 12 - 48 Vdc.
Max. speed: 846 mm/s.
Max. force 4 kN continuous, 6 kN peak.
Stroke lengths up to 450 mm.
Hall effect, incemental encoder or absolute position feedback.
Easy to control software tool including:
- programmeerbare I/O's
- homing
- jogging
- teachmode
- proportional control with analog input
Protection class IP54 or IP65.
RS485 (Modbus RTU) for programming and monitoring.
Available bus systems:
- Modbus TCP
- Ethernet IP
- CANopen
- Profinet I/O
LED displays.
8 digital inputs
4 digital outputs
1 analog input (+/- 10V)
1 analog output (0-10V or +10V/-10V)
Optional analog in-/output 4-20 mA
Gas turbine control with Exlar actuators Tritex
Replacement of hydraulic actuators on gas valves for a gas turbine.
Webguiding press paper with Exlar actuator and Bönnekamp rod end
The position of the paper on the roll is measured with sensors and constantly controlled by the Exlar Tritex servo actutator. The Tritex actuator is equipped with an integrated controller with an analog input to which the signal from the sensor is connected. With the standard process control application in the software, the Tritex system is very easy to set up.
In spite of the constant control at 24-hour operation, the service life of the actuator is ensured by the roller-screw spindle in the Exlar actuator.
Belt sander with Exlar servo actuator and Bönnekamp rod end
A belt sander is used for the production of 'High Voltage Cables'. In the belt sander the insulating sheaths of high-voltage cables with a diameter of Ø20 to Ø55mm are highlighted. The sanders and the main shaft rotate while the cable is being fed. The Exlar servo actuator with Bönnekamp rod head ensures the linear displacement in which the control unit is integrated on the Exlar servo actuator.
More information about the customer and the application can be read here.
-
Roller screw drive, proven high life time
The specialists of ATB Automation calculate the lifetime per application
-
Software support by ATB Automation
The software engineers at ATB Automation assist in programming and commissioning via the help desk or on site